R&S SMJ100A, Operating Manual

Page: 167 / 874

Instrument Function
R&S
®
SMJ100A
151 Operating Manual 1403.7458.32 ─ 14
Confirm Password ← Change Security Password
Confirms the new password by repeating.
Note: The new password will not be assigned until you select the Change Password
button.
Change Password ← Change Security Password
Changes the password accordingly.
Note: Keep in mind, that a changed password is never reset, even if you perform a
factory preset.
LAN Connections
Enables the LAN interface.
It is not possible to access the instrument via LAN while the LAN connection is dis-
abled.
Note: The setting will not be assigned until you enter the Security Password and con-
firm with Accept .
USB Storage
Enables the USB interfaces.
The instrument does not recognize any device connected to the USB interface when
the interface is disabled.
Note: The setting will not be assigned until you enter the Security Password and con-
firm with Accept .
Annotation Frequency
Enables/disables the display of the currently used frequency in the header of the
instrument.
Note: The setting will not be assigned until you enter the Security Password and con-
firm with Accept .
Remote command:
:DISPlay:ANNotation:FREQuency
on page 528
Annotation Amplitude
Enables/disables the display of the currently selected level in the header of the instru-
ment.
Note: The setting will not be assigned until you enter the Security Password and con-
firm with Accept .
Remote command:
:DISPlay:ANNotation:AMPLitude
on page 528
Security Password
Enters the password that is required to enable or to disable the settings protected by a
security password. Default is '123456'.
Note: It is highly recommended that you to change the default security password
before connecting the instrument to the network.
All settings are only accepted after the "Accept" button is pressed.
General Instrument Settings