R&S SMJ100A, Operating Manual

Page: 152 / 874

Instrument Function
R&S
®
SMJ100A
136 Operating Manual 1403.7458.32 ─ 14
5.2.3.5 NRP-Z Info/Update
The "NRP-Z Info/Update…" dialog covers information on connected power sensors,
like serial number, revision state and features of the particular sensor. You can directly
perform an update of the sensor firmware.
► To access this dialog, select "Setup > System > NRP-Z Info/Update…".
The "NRP-Z Info / Update" dialog indicates the connected R&S NRP-Z Power Sen-
sors with specific information and contains the functions to update the firmware of
a connected sensor.
The remote commands required to remotely configure the power sensor settings are
described in
Chapter 7.15, "SENSe, READ and INITiate Subsystems" , on page 558.
How to update an R&S NRP sensor
To perform an R&S NRP sensor update proceed as follows:
1. Open the R&S website http://www.rohde-schwarz.com in section "Power Meters &
Voltmeters > R&S NRP-Z Sensors".
2. Select the respective sensor, e.g. R&S NRP-Z81.
3. Select "Downloads > Firmware" and the offered firmware suitable for your sensor.
4. Transfer and save the firmware on the instruments, for example in the
D:\user\
directory.
5. Connect the sensor to the R&S SMJ and select "Setup > System > NRP-Z Info
Update" to open the dialog.
6. Select the sensor in the left sensor selection field.
7. Select the update file with "Select NRP File".
8. Start the update procedure with "Run Update".
The update starts and a bar indicates the progress.
General Instrument Settings