R&S SMCVB-K161, User Manual

Page: 11 / 81

ATSC-M/H Configuration and Settings
R&S
®
SMCVB-K161
11 User Manual 1179.1035.02 ─ 02
4 ATSC-M/H Configuration and Settings
Access:
► Select "Baseband > ATSC-M/H".
The remote commands required to define these settings are described in Chapter 6,
"Remote-Control Commands" , on page 46.
Settings:
● General Settings ......................................................................................................11
● Input Signal Settings ............................................................................................... 12
● Coding Settings .......................................................................................................23
● Global Connector Settings ...................................................................................... 26
● TS Player ................................................................................................................ 27
● Local IP Data Network Settings .............................................................................. 36
4.1 General Settings
Access:
► Select "Baseband > ATSC-M/H".
This tab provides default settings, "Save/Recall" settings and settings necessary to
define the reference point of the vestigial sideband (VSB).
Settings:
State .............................................................................................................................. 11
Set To Default ................................................................................................................12
Save/Recall ................................................................................................................... 12
VSB Frequency ............................................................................................................. 12
State
Activates the standard and deactivates all the other digital standards and digital modu-
lation modes in the same path.
Remote command:
[:SOURce<hw>]:BB:ATSM:STATe
on page 47
General Settings