R&S SMCVB-K156, User Manual

Page: 43 / 79

Performing T-DMB/DAB Signal Generation Tasks
R&S
®
SMCVB-K156
43 User Manual 1179.1029.02 ─ 02
5 Performing T-DMB/DAB Signal Generation
Tasks
This chapter tells you how to configure the R&S SMCV100B to generate signals for
simple receiver tests.
● Configuring the Input Signal ....................................................................................43
5.1 Configuring the Input Signal
This chapter provides an overview of the different input signals, that the
R&S
SMCV100B uses as modulation data.
● How to Apply an External IP Input Signal ............................................................... 43
● How to Apply an External TS Input Signal .............................................................. 45
● How to Generate an Internal TS Signal .................................................................. 47
5.1.1 How to Apply an External IP Input Signal
To connect the R&S SMCV100B to local IP data network
1. Connect the IP source to the "IP Data" connector of the R&S SMCV100B.
See chapter "Connecting to IP Data Interface" in the R&S SMCV100B Getting Star-
ted user manual.
2. Select "Input Signal > General > Source > External".
3. Select "Input Signal > General > Input > IP".
4. In the "IP Channel x" side tab, click "Local IP Data Network".
By default, the R&S SMCV100B assigns the IP address automatically using DHCP
("Address Mode > Auto (DHCP)").
5. If "Network Status > Disconnected", try "Restart Network".
Configuring the Input Signal