R&S SMBVB-K548, User Manual

Page: 11 / 22

Crest Factor Reduction Settings
R&S
®
SMBVB-K548
11 User Manual 1179.0922.02 ─ 01
4 Crest Factor Reduction Settings
Prerequisite: An ARB file is loaded and enabled.
Access:
► Select the "Baseband > ARB > Crest Factor Reduction".
The remote commands required to define these settings are described in Chapter 5,
"Remote-Control Commands" , on page 15.
Settings:
State .............................................................................................................................. 11
Generate Waveform ...................................................................................................... 12
Algorithm ....................................................................................................................... 12
Desired Crest Factor Delta ............................................................................................12
Max Iterations ................................................................................................................12
Original Crest Factor ..................................................................................................... 12
Resulting Crest Factor .................................................................................................. 12
Filter Mode .................................................................................................................... 12
Channel Spacing ...........................................................................................................13
Signal Bandwidth .......................................................................................................... 13
Stopband Freqeuncy .....................................................................................................14
Passband Freqeuncy .................................................................................................... 14
Maximum Filter Order ................................................................................................... 14
State
Enables the crest factor reduction calculation.
Note: You cannot activate the crest factor reduction and the notch filter simultaneously.
Enabling the notched filter automatically disables the crest factor reduction.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:CFR[:STATe]
on page 16