Getting Started
R&S
®
SMA100B
41
User Manual 1178.3834.02 ─ 03
Figure 2-5: Rear panel view of the R&S
SMA100B RF Signal Generator with height unit 3HU (option
R&S
SMAB-B93)
1 = IEC 625/IEEE 488 connector
2 = USB IN connector (type micro-B)
3 = LAN connector
4 = USB connector (type A)
5 = V/GHZ X-AXIS and Z-AXIS output connectors (BNC)
6 = STOP input and output connector (BNC)
7 = MARKER USER1 output connector (BNC)
8 = REF IN 1GHz and REF OUT 1GHz connectors (SMA)
9 = REF IN and REF OUT connectors (BNC)
10 = EFC input connector (BNC)
11 = INST TRIG input connector (BNC)
12 = SIGNAL VALID output connector (BNC)
13 = CLK SYN and CLK SYN N output connectors (SMA)
14 = PULSE SYNC, PULSE VIDEO and PULSE EXT connectors (BNC)
15 = LF output connector (BNC)
16 = EXT 1/2 input connectors (BNC)
17 = AC power supply connection and main power switch
18 = RF output connector
19 = Serial number (last six digits in the string 1419.8888.02-<serial number>)
2.2.2.1
Connectors
IEC 625/IEEE 488
Option: R&S
SMAB-B86
GPIB-bus interface for remote control of the instrument.
The IEC 625 interface is in compliance with IEEE488 and SCPI. A computer for remote
control can be connected via this interface. To set up the connection, we recommend
that you use a shielded cable.
Note:
To avoid electromagnetic interference (EMI) caused by open lines, always termi-
nate any connected IEC-bus cable with an instrument or a controller.
See also
Chapter B.1, "GPIB-Bus Interface"
USB/USB IN
●
Female USB type A connector, to connect devices like a keyboard, a mouse, a
memory stick, or the R&S NRP-Z3/Z4 cable for the R&S NRP sensors
Instrument Tour
