R&S SMA100B, User Manual

Page: 379 / 581

Remote Control Commands
R&S
®
SMA100B
364 User Manual 1178.3834.02 ─ 03
Example: SENS1:TYPE?
Queries the type of sensor.
Response: NRP-Z21
The R&S NRP-Z21 sensor is used.
Usage: Query only
Manual operation: See "Sensor type and serial number" on page 165
:SENSe<ch>[:POWer]:ZERO
Performs zeroing of the sensor.
Zeroing is required after warm-up, i.e. after connecting the sensor.
Note: Switch off or disconnect the RF power source from the sensor before zeroing.
We recommend that you zero in regular intervals (at least once a day), if:
●
The temperature has varied more than about 5 °C.
●
The sensor has been replaced.
●
You want to measure very low power.
Example: SENS1:ZERO
Executes zeroing.
Usage: Event
Manual operation: See " Zero " on page 165
12.15 SOURce Subsystem
The
SOURce
subsystem contains the commands for configuring the digital and analog
signals.
Common suffixes
The following common suffixes are used in remote commands:
Suffix Value range Description
SOURce<hw> [1]
●
SOURce[1] = RF output
(optional keyword)
●
LF output =
SOURce:LFOutput
( SOURce is optional keyword)
● Analog Modulation Subsystems ............................................................................365
● SOURce:CORRection Subsystem ........................................................................388
● SOURce:FREQuency Subsystem .........................................................................395
● SOURce:INPut Subsystem ................................................................................... 402
● SOURce:LFOutput Subsystem ............................................................................. 403
● SOURce:LIST Subsystem .....................................................................................416
● SOURce:NOISe Subsystem ................................................................................. 429
SOURce Subsystem