Preparing for Use
R&S
®
SGT100A
18
User Manual 1176.8674.02 ─ 07
2 Preparing for Use
............................................................................................. 18
..........................................................................................24
Connecting an External PC and Devices
................................................................24
2.1 Putting into Operation
This section describes the basic steps to be taken when setting up the R&S
SGT for
the first time.
Risk of injury and instrument damage
The instrument must be used in an appropriate manner to prevent electric shock, fire,
personal injury, or damage.
●
Do not open the instrument casing.
●
Read and observe the "Basic Safety Instructions" delivered as a printed brochure
with the instrument.
In addition, read and observe the safety instructions in the following sections.
Notice that the data sheet may specify additional operating conditions.
Risk of instrument damage
Note that the general safety instructions also contain information on operating condi-
tions that prevent damage to the instrument. The instrument's data sheet can contain
additional operating conditions.
Risk of electrostatic discharge (ESD)
Electrostatic discharge (ESD) can damage the electronic components of the instrument
and the device under test (DUT). ESD is most likely to occur when you connect or dis-
connect a DUT or test fixture to the instrument's test ports. To prevent ESD, use a wrist
strap and cord and connect yourself to the ground, or use a conductive floor mat and
heel strap combination.
For details, refer to the basic safety instructions included at the front of the manual.
Putting into Operation
