R&S SGT100A, User Manual

Page: 390 / 593

Remote Control Commands
R&S
®
SGT100A
359 User Manual 1176.8674.02 ─ 07
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SLUNit <SLUnit>
The command defines the unit for the entry of the length of the signal sequence
(
SOUR:BB:ARB:TRIG:SLEN
) to be output in the "Single" trigger mode
(
SOUR:BB:ARB:SEQ SING
).
Parameters:
<SLUnit> SEQuence | SAMPle
*RST:
SEQuence
Example: BB:ARB:SEQ SING
sets trigger mode Single.
BB:ARB:TRIG:SLUN SEQ
sets unit Sequence length for the entry of sequence length.
BB:ARB:TRIG:SLEN 2
sets a sequence length of 2 waveforms. The current waveforms
will be output twice after the next trigger event.
Manual operation: See "Signal Duration Unit" on page 111
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SMODe <SMode>
The command selects the extended trigger mode for multi segment waveforms.
Parameters:
<SMode> SAME | NEXT | NSEam | SEQuencer
NSEam = Next Segment Seamless
*RST:
NEXT
Example: SOUR:BB:ARB:SEQ AUTO
selects trigger mode AUTO.
SOUR:BB:ARB:TRIG:SMOD SAME
the same segment of the waveform is output repeatedly.
Manual operation: See "Next Segment Mode" on page 114
[:SOURce<hw>]:BB:ARBitrary:TRIGger:SOURce <Source>
Selects the trigger source.
Parameters:
<Source> INTernal|OBASeband|BEXTernal|EXTernal
INTernal
manual trigger or
*TRG
.
EXTernal|BEXTernal
trigger signal on the USER 1/2 connector.
*RST:
INTernal
Example: SOURce1:BB:ARBitrary:TRIGger:SOURce EXTernal
sets external triggering via the USER 1/2 connector.
Manual operation: See "Trigger Source" on page 111
SOURce Subsystem