R&S SGT100A, User Manual

Page: 173 / 593

Signal Generator Settings
R&S
®
SGT100A
142 User Manual 1176.8674.02 ─ 07
7.4.1 General Analog I/Q Output Settings
Access:
► Select "I/Q Analog > I/Q Analog Settings > General".
Settings:
State ............................................................................................................................142
Set to Default .............................................................................................................. 142
Save/Recall ................................................................................................................. 143
RF Envelope ............................................................................................................... 143
I/Q Output Type ...........................................................................................................143
Mode ........................................................................................................................... 144
I/Q Level Vp EMF ........................................................................................................144
Couple I/Q Bias ........................................................................................................... 144
Bias (EMF) .................................................................................................................. 144
Offset (EMF) ................................................................................................................145
State
Enables/disables the analog I/Q output.
Note: By default, these output connectors are deactivated.
Remote command:
[:SOURce<hw>]:IQ:OUTPut:ANALog:STATe
on page 426
Set to Default
Calls the default settings. The values of the main parameters are listed in the following
table.
I/Q Analog Output Settings