R&S SGT100A, User Manual

Page: 113 / 593

Signal Generator Settings
R&S
®
SGT100A
82 User Manual 1176.8674.02 ─ 07
The files last used are listed in the "Recent Data Sets" section. The directory can be
selected from the center left section. All waveform files (file extension
*.wv
) available
from the selected directory are listed on the right side. The file info (tag contents and
multi-segment state) for the selected file is displayed below the file section.
The "Select..." button selects the marked file. This file is loaded when the ARB modula-
tion is enabled ("State On").
For a description on how to manage the waveform files, refer to Chapter 5.2, "Manag-
ing Files on the R&S SGT" , on page 46.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WAVeform:SELect
on page 389
Waveform Info
Opens a dialog with detailed information about the currently selected waveform.
The waveform information displayed in this dialog depends on whether the selected
waveform file is a multi-segment one or not. All parameters are read-only.
For non-multi segment waveform files, the values of the settings can be queried by
means of the Tag commands (see
Chapter 12, "Waveform and List Format" ,
on page 502).
Remote command:
n.a.
Clock Frequency
Displays or enters the ARB output clock rate.
When the waveform file is loaded, this value is automatically set to the clock rate
defined in the file (Clock tag). The user can subsequently alter the value if necessary.
When intending to work with an external clock source, the frequency to be applied
must be entered here.
Baseband