R&S RTO6, User Manual

Page: 2096 / 2677

Remote control commands
R&S
®
RTO6
2096 User Manual 1801.6687.02 ─ 05
TRIGger<m>:HBTO:DATA:ICONdition <DataIdxOperator>
Sets the condition for the index. You can define an exact value or a value range.
Suffix:
<m>
.
1..3
Parameters:
<DataIdxOperator> EQUal | LTHan | LETHan | GTHan | GETHan | INRange |
RANGe
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding
TRIGger<m>:HBTO:DATA:
IMIN
command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with
TRIGger<m>:HBTO:DATA:IMIN
and
TRIGger<m>:HBTO:DATA:IMAX
.
*RST: INRange
TRIGger<m>:HBTO:DATA:IMIN <DataIndexMin>
Specifies the index bit pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Parameters:
<DataIndexMin> Range: 1 to 65535
Increment: 1
*RST:
1
TRIGger<m>:HBTO:DATA:IMAX <DataIndexMax>
Sets the end value of the index range if
TRIGger<m>:HBTO:DATA:ICONdition
is
set to
INRange
or
OORange
.
Suffix:
<m>
.
1..3
Parameters:
<DataIndexMax> Range: 1 to 65535
Increment: 1
*RST:
0
TRIGger<m>:HBTO:ERRor:PREamble <ErrorPreamble>
Enables / disables trigger on preamble error.
Protocols