Remote control commands
R&S
®
RTO6
1656
User Manual 1801.6687.02 ─ 05
Usage:
Asynchronous command
EXPort:WAVeform:DISPlayoff
<FastExport>
Enables or disables the display update during an Nx Single acquisition.
Parameters:
<FastExport>
ON | OFF
ON: Disables the display update for maximum export speed.
OFF: Enables the display update. The export is slower.
*RST:
OFF
Usage:
Asynchronous command
EXPort:WAVeform:FASTexport
<Enable>
To improve the performance of data export to file, the measurements are performed
slower while the data export speeds up.
Setting parameters:
<Enable>
ON | OFF
Example:
See
Chapter 24.3.5.2, "Exporting waveform data to file"
Usage:
Setting only
Asynchronous command
24.16.5
Waveform histogram export to file
............................................................................................1656
.......................................................................................1656
.............................................................................................1657
..............................................................................................1657
............................................................................................ 1657
EXPort:HISTogram:SELect
<Name>
Selects the histogram to be exported.
Parameters:
<Name>
String with the histogram name.
Example:
See
"Exporting histogram data to file"
Usage:
Asynchronous command
EXPort:HISTogram:INCidence
<Incidence>
Sets the mode of exported data: relative or absolute frequency of amplitude values.
Data management
