Trying Out the Instrument
R&S
®
RTM2000
33
Getting Started 1317.4710.02 ─ 05
Automatic measurements
To obtain more complex measurement results, or results from several channels simul-
taneously, you can configure up to four amplitude and time measurements or pulse
counts, based on the active signal or math waveforms.
For example, you can compare the amplitudes of an active signal waveform with those
of a reference waveform. In the following example you will determine the top and base
levels of the first pulse in the signal. The results are displayed in the result table below
the diagram.
1. Press the MEAS key.
2. Press "Meas. Place" until 1 is highlighted to select the first of the four measurement
positions.
3. Press "Measure 1" until "On" is highlighted.
4. Press "Meas. Type" until "Top Level" is highlighted.
5. Press "Source" until "CH1" is highlighted.
6. Press "Meas. Place" until 2 is highlighted to configure the second measurement
position.
Showing Basic Measurement Results
