R&S NRX-B4, User Manual

Page: 334 / 450

Remote Control Commands
R&S
®
NRX
334 User Manual 1178.5566.02 ─ 05
Parameters:
<fnum> Range: 0 = 4 kHz, 1 = 200 kHz, 2 = maximum bandwidth
*RST: 0
Manual operation: See "Video Bandwidth" on page 121
14.7 Configuring the Test Generator
If the sensor check source (R&S NRX-B1) is installed, you can use it as a power refer-
ence for testing the connected power sensors.
Further Information:
●
Chapter 3.1.2, "Module Bay" , on page 14
●
"Sensor Check Source tab" on page 134
OUTPut:SOURce:STATe
.................................................................................................334
SOURce:OUTPut:STATe
.................................................................................................334
SOURce:POWer[:VALue]
................................................................................................334
SOURce:PULM:STATe
................................................................................................... 334
SOURce[:RF]:FREQuency[:VALue]
..................................................................................335
OUTPut:SOURce:STATe <state>
SOURce:OUTPut:STATe <state>
Requires sensor check source (R&S NRX-B1)
Enables or disables the signal output.
Parameters:
<state> *RST: 0
Manual operation: See "Signal Output" on page 135
SOURce:POWer[:VALue] <value>
Requires sensor check source (R&S NRX-B1)
Sets the output level.
If you enter a value without unit, the unit is defined by
UNIT<Measurement>:
POWer[:VALue]
. For further information, see Chapter 14.4.1.3, "Units" , on page 188.
Parameters:
<value> Range: -40.0 to +20.0
*RST: +0.0
Default unit: dBm
Manual operation: See "Power Level" on page 135
SOURce:PULM:STATe <state>
Requires sensor check source (R&S NRX-B1)
Configuring the Test Generator