Remote Control Commands
R&S
®
NGL200/NGM200
92
User Manual 1178.8736.02 ─ 05
*RCL
<Number>
Recall
Loads the instrument settings from an internal memory identified by the specified num-
ber. The instrument settings can be stored to this memory using the command
with the associated number.
7.2
System Settings Commands
The
SYSTem
subsystem contains the commands for general functions, which do not
affect signal generation directly.
................................................................................................ 93
SYSTem:BEEPer:STATe
<Mode>
SYSTem:BEEPer:STATe?
Sets or queries the beeper tone.
Parameters:
<Mode>
1 | 0
ON
OFF - Control beeper is deactivated.
OFF
ON - Control beeper is activated.
*RST:
ON
Example:
SYSTem:BEEPer:STATe ON
The front panel control beeper is activated.
Example:
SYSTem:BEEPer:STATe?
Queries the state of the front panel control beeper. Returns “0”
for deactivated (OFF) and “1” for activated (ON) control beeper.
SYSTem:LOCal
Sets the system to front panel control. The front panel control is unlocked. If the front
panel control was locked with the SCPI command
SYSTem:RWLock
, the message box
of the locked front panel on the instrument display will be disappeared.
Usage:
Setting only
System Settings Commands
