R&S FSW Series, User Manual, Page: 711 / 1450

General Instrument Setup
R&S
®
FSW
711 User Manual 1173.9411.02 ─ 43
IP Address or Computer name of Signal Generator ....................................................711
└ 123/ABC ........................................................................................................711
└ Password ...................................................................................................... 711
Test Connection ...........................................................................................................711
Connect/Disconnect .................................................................................................... 712
View Signal Generator ................................................................................................ 712
IP Address or Computer name of Signal Generator
The IP address or computer name of the signal generator connected to the R&S FSW
via LAN.
For tips on how to determine the default computer name, see Chapter 5.1.5.3, "Using
Computer Names" , on page 41, or the signal generator's user documentation.
By default, the IP address is expected. To enter the computer name, toggle the
"123"/"ABC" button to "ABC".
Note: While a connection to a signal generator is established, you cannot change the
connection information.
The IP address / computer name is maintained after a [PRESET], and is transferred
between applications. However, when you switch applications, the control is disabled in
the other applications. Only one application can control a generator at any time.
Select
"Test Connection" on page 711 to establish a temporary connection from the
R&S FSW to the specified signal generator.
If a connection to a signal generator is already configured, the connection data is provi-
ded for information only.
Remote command:
CONFigure:GENerator:IPConnection:ADDRess
on page 1308
123/ABC ← IP Address or Computer name of Signal Generator
By default, the TCPIP address is expected. To enter the computer name, toggle the
"123"/"ABC" button to "ABC".
Password ← IP Address or Computer name of Signal Generator
Enter the password required to operate the connected signal generator.
Test Connection
The R&S FSW attempts to establish a connection to the signal generator.
If an instrument is connected, the following information is displayed:
●
Device type
●
Name and serial number
System Configuration Settings