R&S FSW Series, User Manual

Page: 349 / 1450

Measurements and Results
R&S
®
FSW
349 User Manual 1173.9411.02 ─ 43
For more information see Chapter 7.13.3.1, "Resolution Bandwidth and Filter Types" ,
on page 334.
Remote command:
Filter type:
[SENSe:]BANDwidth[:RESolution]:TYPE
on page 1032
Filter bandwidth:
[SENSe:]BANDwidth[:RESolution]
on page 1031
7.13.4.3 LISN Control Settings
Access : [MEAS CONFIG] > "LISN Config"
For measurements with power lines, the following settings are available for the
R&S
FSW to control which phase of the LISN is to be tested (e.g. for EMI measure-
ments). LISN control requires the EMI measurement (R&S FSW-K54) option.
For more information see Chapter 7.13.3.4, "Controlling V-Networks (LISN)" ,
on page 339.
LISN Type ................................................................................................................... 349
Phase .......................................................................................................................... 350
150 kHz Highpass ....................................................................................................... 350
LISN Type
Selects the network type and activates output to the network via the user port of the
R&S
FSW. The network type determines the supported phases (see Table 7-20 ).
"Off" disables LISN control and output.
Remote command:
INPut<ip>:LISN[:TYPE]
on page 999
Electromagnetic Interference (EMI) Measurement