Remote Commands
R&S
®
FSW
1209
User Manual 1173.9411.02 ─ 43
14.8.4
Configuring Display and Limit Lines
The commands required to configure display and limit lines in a remote environment
are described here.
................................................................................... 1209
..........................................................................................1211
14.8.4.1
Configuring Display Lines
The following commands configure vertical and horizontal display lines.
.............................................................................................1209
.................................................................................. 1209
............................................................................................. 1210
...................................................................................1210
............................................................................................. 1210
................................................................................... 1211
CALCulate<n>:DLINe<dl>
<Position>
This command defines the (horizontal) position of a display line.
Suffix:
<n>
.
<dl>
1 | 2
Parameters:
<Position>
The value range is variable.
You can use any unit you want, the R&S
FSW then converts the
unit to the currently selected unit. If you omit a unit, the
R&S
FSW uses the currently selected unit.
*RST:
(state is OFF)
Default unit: DBM
Example:
CALC:DLIN2 -20dBm
Positions the second display line at -20 dBm.
Manual operation:
See
"Horizontal Line 1/ Horizontal Line 2"
CALCulate<n>:DLINe<dl>:STATe
<State>
This command turns a display line on and off
Suffix:
<n>
.
<dl>
1 | 2
Parameters:
<State>
ON | OFF | 0 | 1
OFF | 0
Switches the function off
Analyzing Measurements (Basics)
