R&S FSW Series, User Manual

Page: 1196 / 1450

Remote Commands
R&S
®
FSW
1196 User Manual 1173.9411.02 ─ 43
CALCulate<n>:MARKer<m>:COUNt
.............................................................................. 1196
CALCulate<n>:MARKer<m>:COUNt:FREQuency?
.......................................................... 1196
CALCulate<n>:MARKer<m>:COUNt:RESolution
............................................................. 1197
CALCulate<n>:MARKer<m>:COUNt <State>
This command turns the frequency counter at the marker position on and off.
The frequency counter works for one marker only. If you perform a frequency count
with another marker, the R&S
FSW deactivates the frequency count of the first marker.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
INITiate<n>:CONTinuous
on page 835.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example: INIT:CONT OFF
Switches to single sweep mode.
CALC:MARK ON
Switches on marker 1.
CALC:MARK:COUN ON
Switches on the frequency counter for marker 1.
INIT;*WAI
Starts a sweep and waits for the end.
CALC:MARK:COUN:FREQ?
Outputs the measured value.
Manual operation: See "Signal Count Marker State" on page 533
CALCulate<n>:MARKer<m>:COUNt:FREQuency?
This command queries the frequency at the marker position.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
INITiate<n>:CONTinuous
on page 835.
Before you can use the command, you have to turn on the frequency counter.
Analyzing Measurements (Basics)