R&S FSW Series, User Manual, Page: 1050 / 1450

Remote Commands
R&S
®
FSW
1050 User Manual 1173.9411.02 ─ 43
TRIGger[:SEQuence]:LEVel:VIDeo
................................................................................ 1053
TRIGger[:SEQuence]:SLOPe
........................................................................................ 1053
TRIGger[:SEQuence]:SOURce
......................................................................................1053
TRIGger[:SEQuence]:TIME:RINTerval
............................................................................1055
TRIGger[:SEQuence]:DTIMe <DropoutTime>
Defines the time the input signal must stay below the trigger level before a trigger is
detected again.
Parameters:
<DropoutTime> Dropout time of the trigger.
Range:
0 s to 10.0 s
*RST: 0 s
Default unit: S
Manual operation: See "Drop-Out Time" on page 485
TRIGger[:SEQuence]:HOLDoff[:TIME] <Offset>
Defines the time offset between the trigger event and the start of the sweep.
A negative offset is possible for time domain measurements.
For the trigger sources "External" or "IF Power", a common input signal is used for both
trigger and gate. Therefore, changes to the gate delay will affect the trigger offset as
well.
Parameters:
<Offset> For measurements in the frequency domain, the range is 0 s to
30 s.
For measurements in the time domain, the range is the negative
sweep time to 30
s.
*RST: 0 s
Default unit: S
Example: TRIG:HOLD 500us
Manual operation: See "Trigger Offset" on page 485
TRIGger[:SEQuence]:IFPower:HOLDoff <Period>
This command defines the holding time before the next trigger event.
Note that this command can be used for any trigger source , not just IF Power
(despite the legacy keyword).
Note: If you perform gated measurements in combination with the IF Power trigger, the
R&S FSW ignores the holding time for frequency sweep, FFT sweep, zero span and
I/Q data measurements.
Setting Basic Measurement Parameters