R&S FSW-K7, User Manual, Page: 195 / 407

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
195 User Manual 1173.9240.02 ─ 23
Manual operation: See "Handover Freq." on page 57
[SENSe:]MIXer:FREQuency:STARt?
This command queries the frequency at which the external mixer band starts.
Example: MIX:FREQ:STAR?
Queries the start frequency of the band.
Usage: Query only
Manual operation: See "RF Start / RF Stop" on page 56
[SENSe:]MIXer:FREQuency:STOP?
This command queries the frequency at which the external mixer band stops.
Example: MIX:FREQ:STOP?
Queries the stop frequency of the band.
Usage: Query only
Manual operation: See "RF Start / RF Stop" on page 56
[SENSe:]MIXer:HARMonic:BAND:PRESet
This command restores the preset frequency ranges for the selected standard wave-
guide band.
Note: Changes to the band and mixer settings are maintained even after using the
PRESET function. Use this command to restore the predefined band ranges.
Example: MIX:HARM:BAND:PRES
Presets the selected waveguide band.
Usage: Event
Manual operation: See "Preset Band" on page 57
[SENSe:]MIXer:HARMonic:BAND <Band>
This command selects the external mixer band. The query returns the currently
selected band.
This command is only available if the external mixer is active (see
[SENSe:]MIXer[:
STATe]
on page 192).
Parameters:
<Band> KA | Q | U | V | E | W | F | D | G | Y | J | USER
Standard waveguide band or user-defined band.
Manual operation: See "Band" on page 57
Configuring the Measurement