R&S FSW-K7, User Manual

Page: 177 / 407

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
177 User Manual 1173.9240.02 ─ 23
11 Remote Commands for Analog Demodula-
tion Measurements
The commands required to perform measurements in the Analog Demodulation appli-
cation in a remote environment are described here.
It is assumed that the R&S FSW has already been set up for remote control in a net-
work as described in the R&S FSW User Manual.
A programming example at the end of the remote commands description demonstrates
the most important commands in a typical application scenario, see
Chapter 11.11,
"Programming Example" , on page 376.
Status registers
The R&S FSW-K7 option uses the status registers of the base unit (except for the
STATus:QUEStionable:ACPLimit
register).
For a description see the R&S FSW User Manual.
General R&S FSW Remote Commands
The application-independent remote commands for general tasks on the R&S FSW are
also available for Analog Demodulation measurements and are described in the
R&S
FSW User Manual. In particular, this comprises the following functionality:
●
Managing Settings and Results
●
Setting Up the Instrument
●
Using the Status Register
Channel-specific commands
Apart from a few general commands on the R&S FSW, most commands refer to the
currently active channel. Thus, always remember to activate an Analog Demodulation
channel before starting a remote program for an Analog Demodulation measurement.
● Introduction ........................................................................................................... 178
● Common Suffixes ..................................................................................................182
● Activating Analog Demodulation Measurements .................................................. 183
● Configuring the Measurement ...............................................................................187
● Capturing Data and Performing Sweeps ...............................................................294
● Configuring the Result Display ..............................................................................299
● Retrieving Results .................................................................................................307
● Analyzing Results ..................................................................................................319
● Importing and Exporting I/Q Data and Results ......................................................374
● Deprecated Commands ........................................................................................ 375
● Programming Example ..........................................................................................376