R&S FSV-K7, Operating Manual, Page: 39 / 262

Analog Demodulation Option R&S FSV–K7
R&S
®
FSV-K7/K7S
39 Operating Manual 1176.7561.02 ─ 06
Phase Wrap On/Off ← PM
Activates/deactivates the phase wrap.
On The phase will be displayed in the range ±180° (± Π). For example, if the phase e180°,
360° is subtracted from the phase value, with the display thus showing >-180°.
Off The phase will not be wrapped.
This softkey is available in the PM signal displays.
Remote command:
CALC:FORM PHAS
(see
CALCulate<n>:FORMat
on page 93)
RF Power
Selects RF power as the modulation type, changes the signal display, and opens a
submenu to set the measurement configuration.
In single sweep mode, the data is determined from the current I/Q data set, i.e. a
change to a different type does not trigger a new measurement.
This menu is also displayed when you press the [MEAS CONFIG] key after changing
the modulation type.
Remote command:
CALC:FEED 'XTIM:RFPower'
(see
CALCulate<n>:FEED
on page 90)
Display Config ← RF Power
See "Display Config" on page 28.
Select Trace ← RF Power
See "Select Trace" on page 30.
Demod BW ← RF Power
See "Demod BW" on page 30.
Meas Time ← RF Power
See "Meas Time" on page 31.
AF Filter ← RF Power
See "AF Filter" on page 31.
AF Range ← RF Power
See "AF Range" on page 34.
Time Domain Zoom ← RF Power
See "Time Domain Zoom" on page 36.
Squelch ← RF Power
See "Squelch" on page 37.
Squelch Level ← RF Power
See "Squelch Level" on page 37.
Softkeys of the Analog Demodulation option