R&S FSV-K7, Operating Manual, Page: 28 / 262

Analog Demodulation Option R&S FSV–K7
R&S
®
FSV-K7/K7S
28 Operating Manual 1176.7561.02 ─ 06
└ Squelch ...........................................................................................................38
└ Squelch Level ................................................................................................. 38
└ Zero Phase Reference Point ...........................................................................38
└ Phase Wrap On/Off .........................................................................................39
RF Power ...................................................................................................................... 39
└ Display Config .................................................................................................39
└ Select Trace ....................................................................................................39
└ Demod BW ......................................................................................................39
└ Meas Time ...................................................................................................... 39
└ AF Filter .......................................................................................................... 39
└ AF Range ........................................................................................................39
└ Time Domain Zoom .........................................................................................39
└ Squelch ...........................................................................................................39
└ Squelch Level ................................................................................................. 39
Display Config ............................................................................................................... 40
AM
Selects AM as the modulation type, changes the signal display, and opens a submenu
to set the measurement configuration.
In single sweep mode, the data is determined from the current I/Q data set, i.e. a
change to a different type does not trigger a new measurement.
This menu is also displayed when you press the [MEAS CONFIG] key after changing
the modulation type.
Remote command:
CALC:FEED 'XTIM:AM'
(see
CALCulate<n>:FEED
on page 90)
Display Config ← AM
You configure the display settings for the results in the "Display Configuration" dialog
box. This dialog box contains the following tabs:
●
"Screen A-D": a separate tab for each of the four available screens
●
"Predefined": for predefined display configurations
Screen A-D ← Display Config ← AM
For each of the four available screens you can configure what is to be displayed. To
define the result display configuration for a screen, select the corresponding tab. For
each screen you can define:
Softkeys of the Analog Demodulation option