R&S FSPN, User Manual

Page: 342 / 555

Remote Control
R&S
®
FSPN
342 User Manual 1179.4363.02 ─ 01
Example: //Define a maximum voltage of 5 V
SOUR:VOLT:AUX:LEV:LIM:HIGH 5
Manual operation: See "Defining the output level" on page 125
SOURce:VOLTage:AUX:LEVel:LIMit:LOW <Voltage>
This command defines the minimum voltage that may be supplied by the V
aux
source.
Parameters:
<Voltage> <numeric value>
Range:
-10 to 10
*RST: 0
Default unit: V
Example: //Define a minimum voltage of -5 V
SOUR:VOLT:AUX:LEV:LIM:LOW -5
Manual operation: See "Defining the output level" on page 125
SOURce:VOLTage:AUX:LEVel[:STATe] <State>
This command turns the auxiliary voltage source (V
aux
) on and off.
Note that DC power is actually supplied only if you additionally activate the outputs in
general.
Prerequisites for this command
●
Turn on DC power sources (
SOURce:VOLTage[:STATe]
).
Parameters:
<State> ON | OFF | 1 | 0
*RST:
OFF
Example: //Turns on the V
aux
source.
SOUR:VOLT:AUX:LEV ON
Manual operation: See "Turning the output on and off" on page 124
SOURce:VOLTage:CHANnel:COUPling <State>
This command couples or decouples the DC power configuration across measurement
channels.
Parameters:
<State> ON | 1
DC power configuration is the same across all measurement
channels.
OFF | 0
DC power configuration is different for each measurement chan-
nel.
*RST:
ON
Common Measurement Settings