R&S FSPN, User Manual

Page: 341 / 555

Remote Control
R&S
®
FSPN
341 User Manual 1179.4363.02 ─ 01
Prerequisites for this command
●
Turn on the DC power source (
SOURce:VOLTage[:STATe]
).
Example: //Query current on all DC power sources
SOUR:CURR:SEQ:RES?
would return, e.g.
0.000000, -0.100000, -0.020000
Usage: Query only
Manual operation: See "Reading the actual output levels" on page 126
SOURce:POWer:SEQuence:RESult?
This command queries the actually measured power (U*I) on the DC power sources.
Prerequisites for this command
●
Turn on DC power sources (
SOURce:VOLTage[:STATe]
).
Example: //Query power output by the DC power sources
SOUR:POW:SEQ:RES?
would return, e.g.
0.000000, 1.000000, 0.200000
Usage: Query only
Manual operation: See "Reading the actual output levels" on page 126
SOURce:VOLTage:AUX:LEVel:AMPLitude <Voltage>
This command defines the output voltage for the V
aux
source.
Parameters:
<Voltage> <numeric value>
Range:
-10 to 10
*RST: 0
Default unit: V
Example: //Defines an output voltage of 1 V on the V
aux
source
SOUR:VOLT:AUX:LEV:AMPL 1
Manual operation: See "Defining the output level" on page 125
SOURce:VOLTage:AUX:LEVel:LIMit:HIGH <Voltage>
This command defines the maximum voltage that may be supplied by the V
aux
source.
Parameters:
<Voltage> <numeric value>
Range:
-10 to 10
*RST: 0
Default unit: V
Common Measurement Settings