Network and Remote Operation
R&S
®
FSPN
282
User Manual 1179.4363.02 ─ 01
IP Address
Defines the IP address. The TCP/IP protocol is preinstalled with the IP address
10.0.0.10. If the DHCP server is available ("DHCP On"), the setting is read-only.
The IP address consists of four number blocks separated by dots. Each block contains
3 numbers in maximum (e.g. 100.100.100.100), but also one or two numbers are
allowed in a block (as an example see the preinstalled address).
Subnet Mask
Defines the subnet mask. The TCP/IP protocol is preinstalled with the subnet mask
255.255.255.0. If the DHCP server is available ("DHCP On"), this setting is read-only.
The subnet mask consists of four number blocks separated by dots. Each block con-
tains 3 numbers in maximum (e.g. 100.100.100.100), but also one or two numbers are
allowed in a block (as an example see the preinstalled address).
DHCP
Switches between DHCP server available (On) or not available (Off). If a DHCP server
is available in the network, the IP address and subnet mask of the instrument are
obtained automatically from the DHCP server.
Network Configuration
Opens the standard Windows "Network Configuration" dialog box for further configura-
tion.
10.3.2
GPIB Settings
Access
: [SETUP] > "N Remote" > "GPIB" tab
Alternatively to connecting the R&S
FSPN to a LAN, the GPIB interface can be used to
connect a remote PC. For details see
Chapter 10.1.1.2, "GPIB Interface (IEC 625/IEEE
Network and Remote Control Settings
