R&S FSMR3000, User Manual

Page: 417 / 733

Remote Commands
R&S
®
FSMR3000
417 User Manual 1179.0116.02 ─ 02
Offset Analyzer Generator
F
ator Deno
Numerator
F F
  
min
Suffix:
<si>
.
irrelevant
<gen>
Parameters:
<Value> <numeric value>
*RST:
1
Example: //Define multiplication factor of 4/3; the transmit frequency of the
generator is 4/3 times the analyzer frequency
SOUR:EXT:FREQ:NUM 4
SOUR:EXT:FREQ:DEN 3
Manual operation: See "(Automatic) Source Frequency (Numerator/Denominator/
Offset)" on page 132
SOURce<si>:EXTernal<gen>:FREQuency:OFFSet <Offset>
This command defines the frequency offset of the generator with reference to the ana-
lyzer frequency.
Select the offset such that the frequency range of the generator is not exceeded if the
following formula is applied to the start and stop frequency of the analyzer:
Offset Analyzer Generator
F
ator Deno
Numerator
F F
  
min
Suffix:
<si>
.
irrelevant
<gen>
Parameters:
<Offset> <numeric value>, specified in Hz, kHz, MHz or GHz, rounded to
the nearest Hz
*RST:
0 Hz
Default unit: HZ
Example: //Define an offset between generator output frequency and ana-
lyzer frequency
SOUR:EXT:FREQ:OFFS 10HZ
Manual operation: See "(Automatic) Source Frequency (Numerator/Denominator/
Offset)" on page 132
SOURce<si>:EXTernal<gen>:POWer[:LEVel] <Level>
This command sets the output power of the selected generator.
Configuring the Measurement