R&S ESW-K58, User Manual

Page: 37 / 103

Configuration
R&S
®
ESW-K58
37 User Manual 1179.0880.02 ─ 03
[SENSe:]MAPD:CHANnel<n>:DELete
on page 85
[SENSe:]MAPD:CHANnel<n>:ELIMit
on page 85
[SENSe:]MAPD:CHANnel<n>:EMARgin
on page 85
[SENSe:]MAPD:CHANnel<n>:EVALuation
on page 86
[SENSe:]MAPD:CHANnel<n>:INSert
on page 86
[SENSe:]MAPD:CHANnel<n>:LOAD
on page 86
[SENSe:]MAPD:CHANnel<n>:PLIMit
on page 87
[SENSe:]MAPD:CHANnel<n>:PMARgin
on page 87
[SENSe:]MAPD:CHANnel<n>:POPulate
on page 84
[SENSe:]MAPD:CHANnel<n>:RFRequency
on page 87
[SENSe:]MAPD:CHANnel<n>:SAVE
on page 88
5.8 Display configuration
Access : "Overview" > "Display Config"
The signal can be displayed using various evaluation methods. All evaluation methods
available for the current application are displayed in the evaluation bar in SmartGrid
mode.
For a description of the available evaluation methods see Chapter 3, "Measurements
and result displays" , on page 13.
5.9 Sweep settings
The sweep settings provide functionality to switch between a single measurement and
a continuous measurement.
Continuous Sweep / Run Cont
While the measurement is running, the "Continuous Sweep" softkey and the [RUN
CONT] key are highlighted. The running measurement can be aborted by selecting the
highlighted softkey or key again. The results are not deleted until a new measurement
is started.
Note: Sequencer. Furthermore, the [RUN CONT] key controls the Sequencer, not indi-
vidual sweeps. [RUN CONT] starts the Sequencer in continuous mode.
Remote command:
Measurement mode:
INITiate<n>:CONTinuous
on page 88
Run measurement:
INITiate<mt>[:IMMediate]
on page 88
Single Sweep / Run Single
Initiates a single measurement. If measurement parameters were changed after the
previous sweep, the results of the previous sweep are cleared when a new sweep is
started.
Sweep settings