R&S esu, Quick Start Manual

Page: 117 / 223

Quick Start Guide 1302.6163.62 - 04 5.13
R&S ESU Basic Measurement Examples
Performing a Level and Frequency Measurement
Fig. 5-6 Analysis of single frequencies with standard measurement time and several
detectors
11.From overview to standard-conformal measurement
➢
Data reduction and automatic routines for final measurement
The R&S ESU offers several data reduction methods for interactive or automatic final
measurements. For details refer to the Operating Manual, chapter 4.
➢
Limit lines
A final measurement to standard can be performed when active limit lines are displayed
in the diagram during the described analysis and measurements are repeated at all
critical frequencies using the standard measurement time and a corresponding detector.
For details refer to the Operating Manual, chapter 4.
➢
Transducer
Care should be taken that the correction values or transducer factors available in tabular
form are considered in the measurement result when accessories with frequency-
dependent characteristics are used. Several correction tables can be combined to form
a transducer set. For details refer to the Operating Manual, chapter 4.