R&S ESR Series, User Manual

Page: 201 / 1126

Receiver Mode
R&S
®
ESR
198 User Manual 1175.7068.02 ─ 12
150 kHz Highpass Filter
Turns the highpass filter avaiable with the R&S ENV216 network on and off.
For more information see Chapter 5.2.5, "V-Networks Control (LISN)" , on page 173.
Remote command:
Highpass filter for the scan:
INPut:LISN:FILTer:HPAS[:STATe]
on page 685
Highpass filter for the final measurement:
[SENSe:]FMEasurement:LISN:FILTer:HPAS[:STATe]
on page 684
5.4 Common Analysis Functions
5.4.1 Trace Configuration
The TRACE key is used to configure the data acquisition for measurement and the
analysis of the measurement data.
The R&S ESR is capable of displaying up to six different traces at a time in a diagram.
A trace consists of a maximum of 691 displayed measurement points on the horizontal
axis (frequency or time). If more measured values than measurement points are availa-
ble, several measured values are combined in one displayed measurement point.
The trace functions include the following:
●
Display mode of the trace
For details on trace modes see
Chapter 5.2.3, "Trace Modes" , on page 171.
●
Evaluation of individual measurement points of a trace. For details on detectors
see
Chapter 5.2.2, "Detectors" , on page 167.
To open the Trace menu
●
Press the TRACE key.
The "Trace" menu is displayed.
Further information
●
Chapter 5.2.3, "Trace Modes" , on page 171
●
Chapter 5.2.2, "Detectors" , on page 167
●
Chapter 6.3.1.6, "ASCII File Export Format" , on page 399
Tasks
●
Chapter 6.3.1.2, "Configuring Traces" , on page 395
●
Chapter 6.3.1.3, "Specifying the Trace Settings" , on page 397
The following table shows all softkeys available in the "Trace" menu. It is possible that
your instrument configuration does not provide all softkeys. If a softkey is only available
Common Analysis Functions