R&S ESR Series, User Manual

Page: 165 / 1126

Receiver Mode
R&S
®
ESR
162 User Manual 1175.7068.02 ─ 12
Skip Frequency
Skips the peak list entry the final measurement is due to measure next and proceeds
with the next peak.
Available for interactive final measurements.
Remote command:
-
Get Maxhold
Uses the highest level that was measured during the scan for the final results instead
of the signal level measured during the final measurement.
Remote command:
-
Measure
Initiates a final measurement on the current peak.
Available for interactive final measurements.
Remote command:
-
Stop Final Measurement
Aborts the final measurement.
Data that has already been collected is lost.
Remote command:
ABORt
on page 640
5.1.7.6 Measurement Settings
The "Meas" menu contains the basic measurement settings and the selection of result
displays (
Chapter 5.1.7.2, "Selecting the Result Display" , on page 156).
► Press the [MEAS] key.
The R&S ESR opens the "Measurement" menu.
Receiver Frequency .................................................................................................... 162
Bargraph Detector .......................................................................................................163
└ Couple to Scan Trace ................................................................................... 163
Measurement Time ..................................................................................................... 163
Demod .........................................................................................................................163
└ Demod (On Off) ............................................................................................ 163
└ AM / FM ........................................................................................................ 163
└ Squelch .........................................................................................................164
Add To Peak List ......................................................................................................... 164
Test Automation .......................................................................................................... 164
Receiver Frequency
Defines the receiver frequency.
Measurements and Result Displays