LTE PRACH Measurement
R&S
®
CMW-KM5xx/-KS5xx
771
User Manual 1173.9628.02 ─ 16
Limits
The limits can be configured via the following remote commands.
Remote command:
4.3.2.7
Additional Softkeys and Hotkeys
The "LTE PRACH" measurement provides some softkey/hotkey combinations which
have no equivalent in the configuration dialog. Most of these hotkeys provide display
configurations (like diagram scaling). They are self-explanatory and do not have any
remote-control commands assigned.
The remaining softkeys > hotkeys are described below. The softkeys "Signaling
Parameter" and "LTE Signaling" are displayed only while the combined signal path
scenario is active and are provided by the "LTE Signaling" application selected as
master application. See also
"Scenario = Combined Signal Path"
While one of the signaling softkeys is selected, the "Config" hotkey opens the configu-
ration dialog of the signaling application, not the configuration dialog of the measure-
ment.
PRACH > Assign Views
Selects the view types to be displayed in the overview. The R&S
CMW does not evalu-
ate the results for disabled views. Therefore, limiting the number of assigned views can
speed up the measurement.
Remote command:
etc.
Signaling Parameter > ...
Provides access to the most essential settings of the "LTE Signaling" application.
Remote command:
Use the commands of the signaling application.
LTE Signaling
Select this softkey and press ON | OFF to turn the downlink signal transmission on or
off.
Press the softkey two times (select it and press it again) to switch to the signaling
application.
Remote command:
Use the commands of the signaling application.
GUI Reference
深圳德标仪器
135-1095-0799
