CDMA2000 Measurements
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
850
User Manual 1173.9511.02 ─ 11
Firmware/Software:
V3.2.20
Options:
R&S CMW-KM012
For additional information concerning syntax elements and returned values refer to
Conventions and General Information
.
CALCulate:CDMA:MEAS<i>:MEValuation:LIST:SEGMent<no>:OBW:CURRent?
FETCh:CDMA:MEAS<i>:MEValuation:LIST:SEGMent<no>:OBW:CURRent?
Returns
CURRent
Occupied Bandwidth (OBW) results for the segment <no> in list
).
The values described below are returned by
FETCh
commands.
CALCulate
com-
mands return limit check results instead, one value for each result listed below.
Suffix:
<no>
.
1..200
The segment number must not exceed the total number of seg-
ments measured.
Return values:
<Reliability>
. In list mode, a zero reliability indicator indi-
cates that the results in all measured segments are valid. A non-
zero value indicates that an error occurred in at least one of the
measured segments.
<SegReliability>
The segment reliability indicates whether one of the following
exceptions occurred in this segment:
0:
No error
3:
Signal overflow
4:
Signal low
8:
Synchronization error
If a combination of exceptions occurs, the most severe error is
indicated.
Range:
0 | 3 | 4 | 8
<OBW>
Occupied bandwidth
Range:
0 to 8 MHz
Default unit: MHz
<LowerFreq>
Lower frequency of the occupied bandwidth.
Range:
- 8 to 0 MHz
Default unit: MHz
<UpperFreq>
Upper frequency of the occupied bandwidth.
Range:
0 to 8 MHz
Default unit: MHz
Usage:
Query only
Firmware/Software:
V1.0.15.20
V2.0.10:
CALCulate:...
command
V2.0.20: New parameters
<LowerFreq>
and
<UpperFreq>
.
Command Reference
深圳德标仪器
135-1095-0799
