R&S CMW-KG8 Series, User Manual

Page: 745 / 964

CDMA2000 Measurements
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
745 User Manual 1173.9511.02 ─ 11
5.3 GUI Reference
The following sections provide detailed reference information on the parameters of the
CDMA2000 multi evaluation and open loop time response (OLTR) measurements. The
GUI reference is structured as follows.
● Measurement Control ............................................................................................745
● Signal Routing and Analyzer Settings ...................................................................746
● Trigger Settings .....................................................................................................750
● Generator Shortcut ................................................................................................753
● Multi Evaluation: Measurement Control ................................................................ 753
● Multi Evaluation: Limit Settings ............................................................................. 756
● Multi Evaluation: Measurement Results ................................................................756
● Multi Evaluation List Mode: Settings View ............................................................ 758
● OLTR: Measurement Control ................................................................................759
● OLTR: Limits ......................................................................................................... 761
● OLTR: Measurement Results ................................................................................761
● Additional Softkeys and Hotkeys ...........................................................................763
5.3.1 Measurement Control
To be able to start any of the comprised TX measurements ("Multi Evaluation" or
"OLTR"), check the corresponding measurement via "Display" > "Select View".
Select View (Hotkey)
To focus on a particular measurement (i.e. to activate its tab) and to select a view
(within this tab) use the softkey-hotkey combination "Display" > "Select View":
●
the radio buttons select the measurement
●
the combo boxes select the view to be activated
Multi Evaluation (Softkey)
This function key is displayed, whenever the multi evaluation measurement is selected.
The softkey shows the current measurement state. Additional measurement substates
can be retrieved via remote control.
Remote command:
FETCh:
​
CDMA:
​
MEAS<i>:
​
MEValuation:
​
STATe?
​
FETCh:
​
CDMA:
​
MEAS<i>:
​
MEValuation:
​
STATe:
​
ALL?
​
GUI Reference
深圳德标仪器
135-1095-0799