R&S CMW-KG8 Series, User Manual

Page: 118 / 964

1xEV-DO Signaling
R&S
®
CMW-KG8xx/-KM8xx/-KS8xx
118 User Manual 1173.9511.02 ─ 11
Adds a comment to the source code of the script.
●
// <remark>
:
Adds a remark to the output of the script.
●
WHILE <query> <> <value>
:
Waits until the <query> returns a certain <value>, e.g. a specific state is reached.
●
WAITKEY <message>
:
Displays a dialog box with a <message> and wait until the box is closed by the
user.
See also: "Remote Control" in the R&S CMW user manual
● General Configuration ...........................................................................................118
● RX Measurements ................................................................................................ 130
2.5.1 General Configuration
The 1xEVDO signaling application is programmed as follows:
●
The application is controlled by SCPI commands with the following syn-
tax:
...:EVDO:SIGN:...
●
After a
*RST
, the forward signal is switched off.
– To activate the forward signal use
SOURce:EVDO:SIGN:STATe ON
.
Query the cell state using
SOURce:EVDO:SIGN:STATe:ALL?
. The result
ON,ADJ
indicates that the forward signal is available.
– To initiate a connection setup use
CALL:EVDO:SIGN:CSWitched:ACTion
CONNect
.
To query the connection states use
FETCh:EVDO:SIGN:CSWitched:STATe?
/
FETCh:EVDO:SIGN:PDATa:STATe?
.
● Specifying General Settings ..................................................................................118
● Configuring Network Settings ................................................................................120
● Configuring the I/Q Settings ..................................................................................122
● Configuring Internal Fading ...................................................................................122
● Configuring the Test Application ........................................................................... 123
● Configuring the Test Application Protocol Stack ...................................................123
● Sending Date and Time Information to the AT ......................................................127
● Setting up a Connection ........................................................................................127
● Query Carrier Acquisition Status ...........................................................................128
● Query AT-related Information ................................................................................128
● Configuring Reverse Power Control Setup ........................................................... 128
● Handoff ..................................................................................................................129
● Configuring Message Monitoring .......................................................................... 130
2.5.1.1 Specifying General Settings
// *************************************************************************
// System-Reset
// *************************************************************************
Programming
深圳德标仪器
135-1095-0799