WCDMA Multi Evaluation Measurement
R&S
®
CMW-KG4xx/-KM4xx/-KS4xx
591
User Manual 1173.9657.02 ─ 11
UL Configuration
The following uplink signal configurations can be selected:
●
QPSK
: QPSK signal (one DPCCH and one DPDCH with the same gain factor).
Measurements related to the code domain (CD Monitor, CDP vs. Slot, CDE vs.
Slot) are not performed in this mode.
●
WCDMA
: R99 signal carrying a single DPCH according to standard 3GPP/FDD
●
HSDPA
: R6 signal with HSDPA related channels (HS-DPCCH)
●
HSUPA
: R6 signal with HSUPA channels (E-DPCH consisting of an E-DPCCH and
up to four E-DPDCHs)
●
HSDPA+HSUPA
: R6 signal with HSDPA related channels and HSUPA channels
●
HSDPA Plus
: R7 signal with HSDPA+ related channels, 16QAM supported
●
HSDPA Plus + HSUPA
: R7 signal with HSDPA+ related channels and HSUPA
channels
The following values cannot be selected but may be displayed while the combined sig-
nal path scenario is active:
●
DC-HSDPA Plus
: R8 signal, dual carrier and HSDPA+ test mode active
●
DC-HSDPA Plus + HSUPA
: R8 signal, dual carrier and HSDPA+ and HSUPA test
mode active
●
DC-HSDPA Plus + DC-HSUPA
: R9 signal, with dual carrier HSDPA+ and dual car-
rier HSUPA channels including support of dual band dual carrier HSDPA+
For more information concerning the listed channels refer to
The high speed signal configurations ("WCDMA + HS...") require option R&S CMW-
KM401. Additionally HSPA+ requires option R&S CMW-KM403 and dual carrier
HSUPA requires option R&S CMW-KM405.
In the Standalone (SA) scenario, this parameter is controlled by the measurement. In
the Combined Signal Path (CSP) scenario, it is controlled by the signaling application.
Remote command:
(SA)
Automatic configuration (CSP)
UL DPDCH Available
Indicates whether a DPDCH is configured for the UL DPCH signal or not. This parame-
ter is ignored for UL Configuration = QPSK.
In the Standalone (SA) scenario, this parameter is controlled by the measurement. In
the Combined Signal Path (CSP) scenario, it is controlled by the signaling application.
Remote command:
(SA)
(CSP)
UE Channels
Indicates which physical channels are contained in the measured signal and which
beta factors and spreading factors are used for these channels.
For the HS-DPCCH three sets of values can be configured, depending on whether it
transports an ACK, NACK or CQI.
GUI Reference
深圳德标仪器
135-1095-0799