WCDMA Signaling
R&S
®
CMW-KG4xx/-KM4xx/-KS4xx
202
User Manual 1173.9657.02 ─ 11
Synchronizing signaling applications means synchronizing the used system time. This
is useful for example for evaluation of message logs, because the time stamps in the
logs are synchronized.
Synchronizing two WCDMA signaling applications means also synchronizing the used
system frame numbers.
This parameter is suspended in the state CEST (connection established).
Remote command:
Synchronization Offset
Configures the timing offset at cell start, relative to the time zone.
Without offset, the cell signal starts with system frame number 0 and a system time
according to the time zone. With an offset, the cell starts with delay: system frame
number 0 plus the |offset| and a system time according to the time zone plus the |off-
set|.
This parameter is suspended in the state CEST (connection established).
Option R&S CMW-KS410 required.
Remote command:
2.4.13 HSDPA Settings
This section contains parameters for HSDPA configuration, e.g. the configuration of the
transport channel HS-DSCH.
All settings require option R&S CMW-KS401, user defined channel configuration
requires also R&S CMW-KS411.
Alternatively use the wizard for the quick configuration of the automatic HSDPA maxi-
mum throughput settings, see
chapter 2.4.4, "Using the WCDMA Wizards"
Fig. 2-92: HSDPA settings
For parameter descriptions refer to the subsections.
GUI Reference
深圳德标仪器
135-1095-0799
