R&S CMW-KG4 Series, User Manual

Page: 148 / 988

WCDMA Signaling
R&S
®
CMW-KG4xx/-KM4xx/-KS4xx
148 User Manual 1173.9657.02 ─ 11
Table 2-27: Pre-defined band combinations
Configuration DL Band A DL Band B
1 I VIII
2 II IV
3 I V
4 I XI
5 II V
Remote command:
CONFigure:
​
WCDMa:
​
SIGN<i>:
​
RFSettings:
​
DBDC
​
2.4.7.3 RF Power Settings
The parameters in this section provide the general power settings.
Fig. 2-55: RF power settings (dual carrier)
RF Power Downlink .....................................................................................................148
└ Output Power (Ior) ........................................................................................ 148
└ AWGN Noise (Ioc) ........................................................................................ 149
└ Geometric Factor (Ior/Ioc) .............................................................................149
└ Total Output Power (Ior+Ioc) ........................................................................ 149
RF Power Uplink > ... .................................................................................................. 150
RF Power Downlink
The following parameters configure the power characteristics in DL.
Output Power (Ior) ← RF Power Downlink
Sets the base level of the generator, representing the total output power of the base
station signal during a call (state connected), averaged over 1 frame but not taking into
account a possible DTX mode for the TFCI bits. The individual physical channel levels
are defined relative to the base level (see
"Level" on page 157).
GUI Reference
深圳德标仪器
135-1095-0799