R&S AREG800A, User Manual

Page: 310 / 411

Remote control commands
R&S
®
AREG800A
310 User Manual 1179.3615.02 ─ 01
:SYSTem:COMMunicate:SYST:NETWork[:IPADdress]:SUBNet:MASK
Sets the subnet mask.
Example: See Example "Configuring the system control network interface"
on page 308.
Manual operation: See "Subnet Mask" on page 115
:SYSTem:COMMunicate:SYST:NETWork:MACaddress <ZynqMacaddress>
Queries the MAC address of the instrument connected to the R&S AREG800A via the
system control interface.
Parameters:
<ZynqMacaddress> string
Example: See Example "Configuring the system control network interface"
on page 308.
Manual operation: See "MAC Address" on page 115
11.14 TEST subsystem
The
TEST
subsystem contains the commands for performing test routines directly at
the hardware assemblies.
The selftetst responses with a
0
if the test is performed successfully, otherwise a value
other than
0
is returned. None of the commands of this system has a
*RST
value.
:TEST<hw>:ALL:STARt
.................................................................................................. 310
:TEST<hw>:ALL:RESult?
................................................................................................310
:TEST<hw>:ALL:STARt
Usage: Event
Starts the selftest. Use the command
:TEST<hw>:ALL:RESult?
to query the result.
:TEST<hw>:ALL:RESult?
Queries the result of the performed selftest. Start the selftest with
:TEST<hw>:ALL:
STARt
.
Return values:
<Result> 0 | 1 | RUNning | STOPped
*RST:
STOPped
Usage: Query only
TEST subsystem