R&S 1332.4500K22, User Manual

Page: 1389 / 1709

Command reference
R&S
®
ZNA
1389 User Manual 1178.6462.02 ─ 20
Parameters for setting and query:
<ReceiverName> String parameter defining the wave(s) followed by the drive port;
see examples below and
Table 7-4 .
Example: *RST; :SENSe:POWer:GAINcontrol:GLOBal MANual
Activate independent GC settings for each drive port.
SENSe:SEGMent1:ADD; :SENSe:SWEep:TYPE SEGMent
Create a new sweep segment no. 1 and activate segmented
sweep type.
SENSe:SEGMent1:POWer:GAINcontrol:CONTrol ON
Enable segmented GC.
SENSe:SEGMent1:POWer:GAINcontrol 'B2D1', LNO
Set the ACG for the received wave b
2
(port 2) in sweep segment
no. 1 to "Low Noise". The setting applies while port 1 is the drive
port.
SENSe:SEGMent1:POWer:GAINcontrol 'A2B2B3D2',
LNO
Set the ACG for the waves a
2
, b
2
, and b
3
in sweep segment no.
1 to "Low Noise". The setting applies while port 2 is the drive
port.
SENSe:SEGMent1:POWer:GAINcontrol? 'B1D2'
Query the ACG setting for the wave b
1
in sweep segment no. 1
while port 2 is the drive port. The response is
1, LDIS
(default
setting).
Manual operation: See "Range" on page 636
[SENSe<Ch>:]SEGMent<Seg>:POWer:GAINcontrol:ALL <Mode>
For the selected segment, this command applies the same manual gain control (GC)
<Mode> to all a and b wave receivers.
These settings apply if and only if segmented GC is enabled (see
[SENSe<Ch>:
]SEGMent<Seg>:POWer:GAINcontrol:CONTrol
).
Note:
●
This applies to the wideband signal path only.
●
Disable segmented GC and use
[SENSe<Ch>:]POWer:GAINcontrol
or
[SENSe<Ch>:]POWer:GAINcontrol:ALL
instead, if no distinction between dif-
ferent sweep segments shall be made.
Suffix:
<Ch>
.
Channel number
<Seg> Sweep segment number
Setting parameters:
<Mode> LDIStortion | LNOise
LDIStortion
0 dB gain, for high input levels
SCPI command reference