Network and Remote Operation
R&S
®
FSPN
273
User Manual 1179.4363.02 ─ 01
Bit No.
Meaning
2
LMARgin 3 FAIL
This bit is set if limit margin 3 is violated.
3
LMARgin 4 FAIL
This bit is set if limit margin 4 is violated.
4
LMARgin 5 FAIL
This bit is set if limit margin 5 is violated.
5
LMARgin 6 FAIL
This bit is set if limit margin 6 is violated.
6
LMARgin 7 FAIL
This bit is set if limit margin 7 is violated.
7
LMARgin 8 FAIL
This bit is set if limit margin 8 is violated.
8 to 14
Not used
15
This bit is always 0.
STATus:QUEStionable:POWer Register
The
STATus:QUEStionable:POWer
register contains information about possible
overload situations that may occur during operation of the R&S
FSPN. A separate
power register exists for each active channel.
You can read out the register with
STATus:QUEStionable:POWer:CONDition?
or
STATus:QUEStionable:POWer[:EVENt]?
STATus:QUEStionable:POWer:DCPNoise
Available for the phase noise application.
The STATus:QUEStionable:POWer:DCPNoise register contains information about the
state and condition of the DC power supply. A separate POWer:DCPNoise register
exists for each active channel.
You can read out the register with
STATus:QUEStionable:POWer:DCPNoise:
or
STATus:QUEStionable:POWer:DCPNoise[:EVENt]?
Table 10-14: Meaning of the bits used in the STATus:QUEStionable:POWer:DCPNoise register
Bit No.
Meaning
0
V
supply
/ I
supply
This bit is set if something is wrong with the voltage or current supply.
1
V
tune
This bit is set if something is wrong with the tuning voltage supply.
2
V
aux
This bit is set if something is wrong with the auxiliary voltage supply.
Remote Control Basics
