R&S 1322.8003K06, User Manual

Page: 252 / 555

Network and Remote Operation
R&S
®
FSPN
252 User Manual 1179.4363.02 ─ 01
Tables provide a fast overview of the bit assignment in the status registers. The tables
are supplemented by a comprehensive description of the status registers.
10.1.3 VISA Libraries
VISA is a standardized software interface library providing input and output functions to
communicate with instruments. The I/O channel (LAN or TCP/IP etc.) is selected at ini-
tialization time by one of the following:
●
The channel–specific address string ("VISA resource string") indicated in
Table 10-1
●
An appropriately defined VISA alias (short name).
A VISA installation is a prerequisite for remote control using the following interfaces:
●
Chapter 10.1.1.2, "GPIB Interface (IEC 625/IEEE 418 Bus Interface)" , on page 248
●
Chapter 10.1.1.1, "LAN Interface" , on page 244
For more information about VISA, refer to the user documentation.
10.1.4 Messages
The messages transferred on the data lines are divided into the following categories:
●
Interface messages
Interface messages are transmitted to the instrument on the data lines, with the
attention line being active (LOW). They are used to communicate between the con-
troller and the instrument. Interface messages can only be sent by instruments that
have GPIB bus functionality. For details see the sections for the required interface.
●
Instrument messages
Instrument messages are employed in the same way for all interfaces, if not indica-
ted otherwise in the description. Structure and syntax of the instrument messages
are described in
Chapter 10.1.5, "SCPI Command Structure" , on page 253. A
detailed description of all messages available for the instrument is provided in the
chapter "Remote Control Commands".
There are different types of instrument messages, depending on the direction they
are sent:
–
Commands
– Instrument responses
Commands
Commands (program messages) are messages the controller sends to the instrument.
They operate the instrument functions and request information. The commands are
subdivided according to two criteria:
●
According to the effect they have on the instrument:
–
Setting commands cause instrument settings such as a reset of the instru-
ment or setting the frequency.
Remote Control Basics