R&S 1322.8003K06, User Manual

Page: 106 / 555

Common Measurement Settings
R&S
®
FSPN
106 User Manual 1179.4363.02 ─ 01
The auto search features are available for phase noise measurements.
The remote commands required to configure the frequency are described in Chap-
ter 11.6.5, "Remote Commands to Configure the Frequency" , on page 356.
Defining the signal frequency ......................................................................................106
Searching for a signal ................................................................................................. 107
Capture Range ............................................................................................................108
Defining the measurement range ................................................................................108
Measuring low frequency and low level signals .......................................................... 108
└ Low signal frequencies ................................................................................. 109
└ Low signal levels ...........................................................................................109
└ Multicarrier signals ........................................................................................ 110
Defining the signal frequency
The "Signal Frequency" is the frequency the signal is transmitted with.
You can define it manually in the corresponding input field or let the R&S FSPN search
for the signal frequency in an automatic frequency search (turn on the "Auto Search" in
that case).
Not available for baseband noise measurements.
Frequency