Command reference
R&S
®
ZNB/ZNBT
924
User Manual 1173.9163.02 ─ 62
Example:
*RST; CALCulate:LIMit:CIRCle:DATA 0, 0, 0.5
Define a circle limit line centered around the origin of the polar
diagram, assigning a radius of 0.5 U.
CALCulate:FORMat POLar
CALCulate:LIMit:CIRCle:DISPlay ON
Activate a polar diagram and show the circle limit line in the dia-
gram.
Manual operation:
See
CALCulate<Chn>:LIMit:CIRCle:FAIL?
Returns a 0 or 1 to indicate whether or not the circle limit check has failed. 0 repre-
sents pass and 1 represents fail
Tip:
to perform a composite (global) limit check.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Example:
See
CALCulate<Chn>:LIMit:CIRCle[:STATe]
Usage:
Query only
Manual operation:
See
CALCulate:LIMit:CIRCle:FAIL:ALL?
[<RecallSet>]
Returns a 0 or 1 to indicate whether or not the circle limit check has failed for at least
one channel in the referenced recall set. 0 represents pass and 1 represents fail
Query parameters:
<RecallSet>
Recall set name; if omitted the active recall set is used
Usage:
Query only
Manual operation:
See
CALCulate<Chn>:LIMit:CIRCle:SOUNd[:STATe]
<Boolean>
Deprecated command
: Since version 3.45, generating sounds is no longer supported
by the analyzer firmware.
Switches the acoustic signal (fail beep) on or off. The fail beep is generated each time
the analyzer detects an exceeded circle limit.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean>
ON | OFF - Fail beep on or off.
*RST:
OFF
Example:
CALCulate:LIMit:CIRCle:STATe ON; SOUNd ON
Switch the limit check on and activate the fail beep.
SCPI command reference
