R&S 1129.7246.03, Operating Manual

Page: 429 / 855

R&S ESU Remote Control – Basics
Status Reporting System
5.24 Operating Manual 1302.6163.12 - 03
5.7.3.4 STATus:OPERation Register
In the CONDition part, this register contains information on which actions the
instrument is being executing or, in the EVENt part, information on which actions the
instrument has executed since the last reading. It can be read using commands
"STATus:OPERation:CONDition?"
or
"STATus:OPERation[:EVENt]?"
.
5.7.3.5 STATus:QUEStionable Register
This register comprises information about indefinite states which may occur if the
unit is operated without meeting the specifications. It can be queried by commands
STATus:QUEStionable:CONDition?
and
STATus:QUEStionable[:
EVENt]?
.
Bit
No. Meaning
0 CALibrating
This bit is set as long as the instrument is performing a calibration.
1 to 7 These bits are not used
8 HardCOPy in progress
This bit is set while the instrument is printing a hardcopy.
9 SCAN results available
This bit is set when a block of scan results is available. Must be enabled by TRAC:FEED:
CONT ALWays
10 Sweep Break
This bit is set when end of sweep range is reached (spurious measurement, mode analyzer).
Command “INIT:CONM” has to be used to proceed.
11 to
12 These bits are not used
13 Threshold signal active
14 This bit is not used
15 This bit is always 0
Bit
No. Meaning
0 to 2 These bits are not used.
3 POWer
This bit is set if a questionable power occurs (cf. also section “STATus:QUEStionable:POWer
Register” on page 5.29 )
4 This bit is not used.
5 FREQuency
The bit is set if a frequency is questionable (cf. section “STATus:QUEStionable:FREQuency
Register” on page 5.26 )
6 This bit is not used.
7 This bit is not used
8 CALibration
The bit is set if a measurement is performed uncalibrated (equivalent to label "UNCAL")