R&G Racing
Unit 1, Shelleys Lane, East Worldham, Alton, Hampshire GU34 3AQ.
PAGE 3 OF 9
PKS0127SI
FITTING INSTRUCTIONS
•
Take the aluminium mounting plate (Item 1) and fit to the base of the side stand from underneath.
•
Carefully pass the clamping plate (Item 2) around the side stand leg, with the countersinks facing
upwards.
•
Sandwich the two plates together around the side stand pad.
•
Apply a small amount (one drop) of Loctite Blue 242 or similar to the end of the threaded area of
each screw.
•
Fit the three M5 bolts (Item 3) as shown in the assembly diagram, clamping the two plates
together and securely mounting onto the side stand
foot.
•
Tighten all bolts evenly and check to ensure the side stand pad clears the chain when in the raised
position.
•
If fitting to older stands that have been worn, the padding strip should be placed in the base plate
to ensure a tighter fit.
ISSUE 2- 30/10/2019 (DM)
CONSUMER NOTICE
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G’s order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill
and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring
that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall
at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified
or used or maintained otherwise than in accordance with R&G’s or manufacturer’s instructions and good engineering practice or
if
the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting its liability for causing
death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability shall be limited to the
amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect the Buyer’s statuto
ry
rights.
R&G RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if
they were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods
must be in re-sellable condition, in the opinion of R&G. All returns are subject to a 25% restocking and handling fee (25% of the
gross value exc. P&P
–
at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No
returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not
refer to faulty goods.
