R&G LP0185BK, Fitting Instructions Manual

Page: 12 / 28

R&G Tail Tidy fits correctly and has equal panel gaps all around. It is suggested to loosen these
bolts whilst fitting the tail tidy and to re-tighten when all the parts are satisfactorily fitted.

Remove the Torx bolt that connects the two plastic surround panels to the OEM licence plate
hanger, as shown in picture 10.

These parts can now be un-clipped from each other and spread apart, as shown in picture 11.

Remove the four push rivets, shown in pictures 12 & 13, by pushing the centre through. These
plastics pins will push through into the OEM licence plate hanger. With the pins out, remove the
outer section of the push rivet.

The top half of the hanger can now be removed by lifting the rear upward and then sliding back to
remove it from the lock barrel, as shown in pictures 14 & 15.

On the underside of the OEM licence plate hanger, remove the two Torx bolts, as shown in picture
16.

The OEM licence plate hanger can now be gently pulled rearward to un-locate the lock and then
dropped clear of the rear of the bike, as shown in picture 17.

Disconnect the wiring connector for the rear light, as shown in picture 18, along with the cable ties
that bunch the wires together.

Using a very small screwdriver, disconnect the indicator connectors, as shown in pictures 19 & 20.
It is a good idea to mark the matching connectors on one side, to ensure the correct re-fitment.

The wiring can now be fed through and the OEM licence plate hanger removed from the bike, as
shown in picture 21.

On the bike, pull the wiring up through the hole on the underside of the tail so that they sit within
the plastic tray, as shown in picture 22.

On the OEM hanger, use a small screwdriver to firstly remove the indicator connector from the
mount and then remove the mount from the hanger by inserting the thin screwdriver under the back
and pushing the prong to one side, as shown in pictures 23 & 24. Do this for both connectors &
mounts.

Remove the key lock barrel from the plastic, by pushing down on the exposed tab and sliding out,
as shown in picture 25.

To fit the R&G Tail Tidy, take the R&G tail light (item 1 – LA0003) and fit the plastic light shroud
(item 2), as shown in picture 26.

Locate this assembly onto the licence plate bracket (item 5 – TB0185 Part 1) and tighten the nuts
on the rear, as shown in pictures 27 & 28.
If fitting R&G Mini Indicators

Take the mini indicator and feed the wires though the hole of one of the indicator adaptors (item 4
– I0041), as shown in picture 29.

Fit one length of heatshrink supplied (item 11) to protect the indicator wiring before feeding the
wires through the indicator mounting hole on the tail tidy, as shown in picture 30. Feed the flanged
nut over the wiring and tighten onto the threaded boss of the indicator.

Take the main plastic body (item 7 – TB0185 Part 2) and feed all the wiring through the hole
below the hole for the lock, as shown in pictures 31 & 32.

To fit the R&G Mini Indicators, the OEM indicator wiring will need to be cut and shut in order to
connect the indicators. To do this, cut through the rear indicator wires about 50mm from the
connector. Strip the ends of the two wires on the connector end and fit the bullet connectors
supplied (item 10 – CON0004) to the two wires for the indicators in order to match them to the
bullet connectors on the R&G Mini Indicators.

If fitting R&G Aero Indicators with LED’s the yellow wire on the Aero Indicators connects with the
black/red or black/blue wire on either indicator and the black wire on the Mini Indicators connects