Page
9
of
19
AB0053
R&G
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
•
Place the longest remaining M10 (120mm long) cap head bolt (
item 9
) into the
upper mounting boss then through the frame bracket and original spacer (engage
the thread but do not tighten at this stage) as shown in
picture 22
.
•
Place the remaining M10 (90mm long) cap head (
item 8
) bolt into the forward
mounting bracket then through the front frame bracket and the original spacer
(engage the thread but do not tighten at this stage) as shown in
picture 23
.
•
Tighten all bolts and nuts ensuring the adventure bars are clear of any other
parts of the motorcycle.
•
Fit the bolt covers (
items 3 and 6
) onto the appropriate bolts.
•
Refit the sprocket cover as original (ensuring the wire/cable guides are refitted as
original) as shown in
picture 24
.
•
Refit the gear shift lever and bolt as original.
ISSUE 1 21/11/2019 (NSY)
CONSUMER NOTICE
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G
may make design changes which do not diminish their performance or visual appeal and supplying them in
such state shall conform to the order. The Buyer acknowledges no representation or warranty (other than as to
title) has been given or will apply to the Products other than those in R&G’s or
der or confirmation and the
Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its particular
purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care
and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any
defective Products R&G shall at its option either supply a replacement or refund the purchase money but shall
not be liable if the Products have been modified or used or maintained otherwise than in accordance with
R&G’s or manufacturer’s instructions and good engineering practice or if the defect ari
ses from accident or
neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal
injury, it shall not be liable for indirect or consequential loss and otherwise its liability shall be limited to the
amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect the
Buyer’s statutory rights.
R&G RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned
direct to us if they were purchased direct from us (customer must prove if necessary). Otherwise to be
returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G. All returns are
subject to a 25% restocking and handling fee (25% of the gross value exc. P&P
–
at the prevailing price at
time of purchase). The customer must pay any and all carriage charges. No returns of discontinued products,
unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty
goods.
